<listing id="5l5pj"></listing><cite id="5l5pj"><video id="5l5pj"><menuitem id="5l5pj"></menuitem></video></cite><cite id="5l5pj"><dl id="5l5pj"><thead id="5l5pj"></thead></dl></cite>
<var id="5l5pj"></var>
<var id="5l5pj"></var>
<var id="5l5pj"><strike id="5l5pj"></strike></var><cite id="5l5pj"><video id="5l5pj"></video></cite>
<var id="5l5pj"><video id="5l5pj"></video></var>
<cite id="5l5pj"><video id="5l5pj"><menuitem id="5l5pj"></menuitem></video></cite>
<var id="5l5pj"></var>
<var id="5l5pj"><strike id="5l5pj"></strike></var>
<cite id="5l5pj"><span id="5l5pj"></span></cite>
主頁 > 產品展示 > 按鍵開關 > 按鍵開關 > 帶燈按鍵開關5.8×5.8×10.2mm
帶燈按鍵開關5.8×5.8×10.2mm

帶燈按鍵開關5.8×5.8×10.2mm

產品規格:5.8×5.8×10.2mm
產品型號:PS-5853A-6PX
產品包裝:1000/袋
聲明:有關于產品的規格、參數、壽命、工作溫度、手感、防水等級等數據,只代表品贊電子內部的測試結果,如需詳細測試方式,請聯系品贊業務人員。

基本說明

Specification
FUNCTION: Momentary action
CONTACT ARRANGEMENT: 1P2T SLIDE SWITCH
 
Electrical
ELECTRICAL SPECIFICATIONS:0.5A/DC30V
CONTACT RESISTANCE:≤100mΩ
INSULATION RESISTANCE(IR):≥100MΩ  DC125V
COMPRESSIVE STRENGTH (WV):AC125V 1MINUTE
STORAGE HUMIDITY:<85%RH
ELECTRICAL LIFE:10,000

MECHANICAL LIFE:100,000
FULL TRAVEL:1.9±0.2mm
 
Environmental
OPERATING TEMPERATURE: -25?C ~+65°C

Molde code:

尺寸圖

規格參數

1. 一般特性 General Characteristics

1.1 額定值(Rating Value): DC30V 1.0A.

1.2 工作溫度(Work Temperature Range): -10℃ ~ 70℃

1.3 存貯溫度(Store Temperature Range): -20℃ ~ 80℃

1.4 正常測試條件(未有特殊說明量測在以下條件進行):
General test condition (Tests and measurements shall be made under the following standard
conditions unless otherwise specified):

正常溫度: 5℃~35℃ 相對濕度: 45%~85% RH 氣 壓: 8,600~10,600 帕
Temperature: 5℃~35℃ Relative humidity: 45%~85% Air pressure: 8,600~10,600 pa

2.產觀品外及尺寸要求 Appearance & Dimension Requirement

2.1 產品外形結構緊湊,無配合不良.
The structure of product is compact, and assembly of parts has no badness.

2.2 產品塑膠部件無嚴重縮水、披鋒、欠注、斑點、破損或變形現象.
The plastic parts of product have no serious defects such as very serious shrink, scarcity,
fleck, disrepair, transmutation, etc.

2.3 產品引腳和外殼無嚴重氧化、臟污、變形、毛刺或電鍍不良.
Lead feet and shell have no serious defects such as oxidation, smudge, disrepair, burr, defects
on plating.

2.4 開關操作順暢,節奏感強,無明顯卡塞現象,(自鎖開關鎖芯鎖住后,允許導芯傾斜正負 2°)
Operating switch is unhindered, rhythmed , and there is not palpable clag.( After the keystoke
is locked, it is normal that the keystoke tilt to one side plus or minus 2 °)

2.5 產品結構及尺寸參見產品規格圖紙。
Construction and dimensions:Refer to individual product drawing. 


 3. 電氣特性 Electronic Characteristics 

No. 

項 目
Item 

測試方法
Test Method 
測試設備
Equipment
特性要求
Requirements 
3.1 接觸電阻
Contact
Resistance
在低電流(≤100mA)條件下測試.
Measured at low current (100mA or
less). 
低電阻測試儀
Low Resistance
Meter 
100mΩ max 
3.2 絕緣阻抗
Insulation
Resistance
測試相鄰引腳之間,引腳與外殼之間的絕緣阻抗.
Measurement shall be made between
adjacent terminals, between
terminal and shell. 
絕緣測試機
InsulationResistance
Tester
100MΩ min 
3.3 耐壓測試
Dielectric
Withstand
Voltage 
輸入一定電壓(50-60Hz,電壓值AC 250V)1 分鐘,
漏電流為2mA,測試鄰近端子間.
Apply certain voltage (50-60Hz,
AC 250V) for 1 minute between
adjacent contacts of the connector
with 2mA leakage sensitivity. 
耐壓測試機
Puncture Tester 
沒 有 絕 緣 破 壞 .
電弧等異常.
No arcing , break
down and damaging
insulation.

4. 機械特性 Mechanical Characteristics 
 
No. 

項 目
Item 

測試方法
Test Method 
測試設備
Equipment
特性要求
Requirements 
4.1 操 作 力
Operation
Force
逐漸施力操作開關按鍵,測量開關到達全部工作行程時
所需的最大操作力度。
Operate the keystoke of the
switch and then increase press
strength gradually, Measured
maximum operation force while
the travel of the switch is full.
測力計

Force Gauge 
240±50gf 
4.2 行 程
Full travel 
垂直操作開關按鍵,量測開關頂端最大移動距離.
Operate the keystoke of the
switch vertically, the travel
distance of keystoke moving from
its free position to maximum
moving distance shall be
measurement. 
游標卡尺

Vernier
Caliper 
2.4±0.2mm

5. 可靠性測 試 Reliability trial
 
No. 

項 目
Item 

測試方法
Test Method 
測試設備
Equipment
特性要求
Requirements 
5.1 可焊性試驗
Solder ability
Test 
端子頂部被浸入焊錫爐中,溫度為 260±5℃,
時間 5±1 秒.
The top of the terminals shall be dipped in the
solder bath at 260±5℃ for5±1
seconds.
控溫錫爐

Solder Stove
引腳至少 95%上錫.
Ninety-five percent of
terminals shall be dipped.
5.2 壽命試驗
Operation Life
開關在壽命試驗設備上以約90 次/分的速度
連續被操作,具體次數見規格圖示。
Switch shall be operated continuously at
about 90 cycles /min without load.
壽命試驗機

Life Tester
壽命: 100,000 次
實驗后:
絕緣電阻:10MΩ Min
操作力:變化在±50%內
開關外觀及結構無損壞。
Life test:100,000cycles
After test:
Insulation resistance:
10MΩ Min
Operating force: Change
should be within ±50% of
specified value.
No abnormalities shall be
recognized in appearance
and construction. 
5.3 耐焊接熱
Resistance
to
Soldering
heat
端子焊接部分浸入焊爐,焊爐溫度 260±
5℃,焊接時間 5±1 秒。(焊接時不可于
端子施加外力)。
Terminals shall be dipped in the solder
bath at 260±5℃ for 5±1 seconds
without additional force for
terminals. 
控溫錫爐

Solder Stove 
本體無變形,能滿足
于機械、電氣性能.
Appearance should
be not damaged,
electrical and
mechanical
characteristics
shall be satisfied.
5.4 耐高溫測試
Resistance to
Heat Test
放置在溫度 80±2℃環境中 96 小時后,
再置于正常條件下 1 小時后測定。
The switch shall be stored at a
temperature of 80±2℃ for 96 hours,
Measurements shall be made after it be
subjected to the standard conditions for
1 hour. 
高低溫
試驗機

High & Low
Temperature
Tester 
外觀,機械及電氣性
能均符合要求。
Appearance,
electrical and
mechanical
characteristics
shall be satisfied.
5.5 耐低溫測試
Resistance to
Cold Test 
放置在溫度-20±2℃環境中 96 小時后,
再置于正常條件下 1 小時后測定。
The switch shall be stored at a
temperature of -20±2℃ for 96 hours,
Measurements shall be made after it be
subjected to the standard conditions for
1 hour. 
高低溫
試驗機

High & Low
Temperature
Tester 
外觀,機械及電氣性
能均符合要求。
Appearance,
electrical and
mechanical
characteristics
shall be satisfied.
5.6 耐濕性測試
Resistance to
Humidity Test
放置于溫度 40±2℃,相對濕度為 90~96%
環境中 96 小時后,再置于正常條件下 1
小時后測定(注意要擦去水滴)。
The switch shall be stored at a
temperature of 40±2℃,relative
humidity 90~96% for 96 hours,
Measurements shall be made after it be
subjected to the standard conditions for
1 hour (Wipe out water drip). 
恒溫恒濕箱

Temperature
& Humidity
Tester
Chamber 
外觀,機械及電氣性
能均符合要求。
Appearance,
electrical and
mechanical
characteristics
shall be satisfied.
5.7 鹽霧實驗
Salt Mist
Test 
試件在下述實驗后測量:
1.溫度: 35±5ºC
2.鹽溶液濃度:5±1%(質量百分比),
3.試驗時間:24 小時,
4.試驗后,將鹽沉積物用水沖掉。
The switch shall be checked after
following test:
1.Temperature: 35±5ºC
2.Salt solution: 5±1%(Solids by mass)
3.Duration: 24 hours,
4.After immersing, salt deposit shall
be removed by running water.
鹽霧
試驗機

Salt Spray
Tester 
在金屬件上沒有嚴重
腐蝕斑點。
No remarkable
corrosion shall be
recognized in metal
parts. 
 
 
 


推薦產品
輕觸開關資訊
撥動開關資訊
檢測開關資訊
SERVICE
0769-82388879

服務熱線

在線咨詢

聯系我們
TEL:0769-82388879
FAX:0769-81888689
MOB:陳先生 135-8089-9958
E-mail:dgjiawen@126.com
Site: www.druckberg.com
Add:廣東東莞市長安鎮上沙北橫路8號18樓
微信掃碼進入小程序
公安備案號 : 44190002003787 ??粵ICP備18078670號-7 ??G-Switch 品贊電子(東莞)有限公司
品贊電子專業生產高質量輕觸開關、防水輕觸開關、輕觸按鍵開關、拔動開關、微型撥動開關等!電話:0769-82388879
技術支持:恒點互聯
日本加勒比中文字幕无码一区